Updating
- Plug Glimly in. Keep it plugged in until the update is done.
- Open
glimly.local. - On the Device tab, tap Check for updates.
- Tap Install update.
Glimly restarts automatically in about a minute. Settings and WiFi are kept. If a settings password is set, Glimly asks for it again.
The settings page also checks for updates. When it shows A new version of Glimly is ready, tap Install update.
Older settings page
Some early units show an older page with a Firmware Update card. If it shows Status: fail and Downloaded: 1 B, that unit can’t update over WiFi and nothing has changed. Update it by cable.
By cable
Without WiFi, or if the update won’t start, update by cable. See By cable.